#84 / 2015
260 West Sunrise Highway, Valley Stream, NY, United States
During this project Denair HVAC NYC provided all necessary mechanical equipment and installed 5 ton condensing unit, 5 ton air handler, steam coil cut into supply air ductwork, ductwork connections, branches with grills, provided refrigeration piping and support as well as condensate drain piping, installed thermostats and drip pan with leak detector.
#83 / 2015
Dutch Ambassador’s Residence
1 Beekman Place, New York, NY, United States
At the residence of Dutch Ambassador, Denair HVAC NYC furnished and installed Unit heater, return grills, thermostat and thermostat control wiring. We also installed ductwork fabricated from our end. Mechanical shop drawings and as-built drawing were submitted to the client.
#82 / 2015
1001 Avenue of the Americas, New York, NY, United States
This was a small project, where Denair furnished and installed ceiling mounted exhaust fans and wall mounted transfer grills.
#81 / 2015
148 Waverly Place, New York, NY, United States
Denair HVAC NYC was asked to install 3 indoor ductless AC units as well as 1 outdoor condenser unit. We provided all necessary piping and performed system start-up.
#80 / 2015
Cure Urgent Care
175 East 96th Street, New York, NY, United States
This project was accomplished by Denair in the shortest time. We furnished and installed two air curtains with door switches, exhaust fans, supply and returns grilles, diffusers as well as duct heaters, thermostats and drip pan with leak detectors. We also produced and installed ductwork with all associated accessories and volume and draft back dampers. At the end of the project we performed system start-up and we kept the equipment under our maintenance for another year to make sure that HVAC system is working at peak performance efficiently.
Merchant Cash & Capital – 6th Floor
460 Park Avenue, New York, NY, United States
In this project, Denair HVAC NYC furnished and installed supply and return grills, diffusers as per client’s specification. We, also, fabricated galvanized ductwork and installed with all associated accessories including volume dampers. Air test and balancing was performed and the client was supplied with certified report and mechanical shop and as-built drawings.
#78 / 2015
Nike Factory Store
2236 Nostrand Ave, Brooklyn, NY, United States
Denair HVAC NYC carried out inspections of the existing equipment and provided the following scope of work: produced ductwork and installed with insulation required, furnished and installed exhaust fans, unit heaters, dampers, air outlets, baseboard heaters, roof exhaust and associated control wiring. The client was provided with all shop and as-built drawings.
#77 / 2015
11-11 34th Ave, Astoria, NY, United States
Client requested mechanical contractor Denair HVAC NYC to provide value engineering to identify the most efficient equipment. Upon completion, suggestion have been made in regards to equipment and installation. The existing equipment was demolished. Denair HVAC installed make-up air handler unit, exhaust fans, grilles, diffusers and louvers. We also fabricated and installed ductwork, branches and accessories as well as volume, fire and motorized dampers. All required thermostats and wiring control were installed. Air balancing was carried out and certified report provided along with shop and as-built drawings.
#76 / 2015
509 5th Ave, New York, NY, United States
Denair HVAC NYC furnished and installed air curtain unit, exhaust fans, diffuser, supply and return grills as per client’s specification. We fabricated and installed paintable ductworks, branches and accessories, volume, blade and fire dampers. We also installed thermostats, temperature and CO2 sensors and associated control wiring. We performed air balancing and provided certified report as well as shop and as-built drawings.
#75 / 2015
193 W 237th St, NY, Bronx, United States
Having satisfied customer at previous Smashburger location, Denair HVAC NYC won another Smashburger project. In Bronx, we furnished and installed all required HVAC equipment including make-up unit, exhaust fan and exhaust hood, performed air test and balancing and provided certified report.
#74 / 2014
Smashburger, New York City
136 William St, New York, NY, United States
At this location, Denair HVAC was asked to carry out inspection of the existing equipment including AC units, make up unit, kitchen fan, exhaust fans, refrigerant and condensate piping. After the inspection, we arranged demolition of the existing ductworks and installed new including flue ductwork, branches and accessories for water heater. Upon completion, we performed system start-up and air balancing with all supporting documentation.
#72 / 2014
335 Adams St, Brooklyn, New York, NY, United States
In this project general contractor requested the following HVAC works: furnish and install HVAC equipment, ductwork and all diffusers, registers and thermostats, provide condensate and refrigerant piping, disconnect existing unused unit and tie new lines for FCUs, furnish and install pump and funnel drain for drain lines, provide FCUs with integral drain pans and leak detectors. Upon completion, we carried out air test and balancing providing certified report.
#71 / 2014
57 W 57th St, New York, NY, United States
Denair HVAC performed demolition of existing ducts and grills, and installed brand new ductworks, supply and return grills and diffusers as well as volume and cable operated dampers. Air balancing was performed and associated certified report provided.
#69 / 2014
460 W 34th St, New York, NY, United States
Denair was requested to do existing equipment inspection. In consequence of inspection, existing diffusers and thermostats were relocated and maintained. VAV boxes were furnished and installed as well as supply and return grills, diffusers and new thermostats and volume/fire dampers. We performed air test and balancing. All the works were done in after office hours to keep the building fully operated.
#68 / 2014
333 337 Bleecker St, New York, NY, United States
The project was accomplished by installing AC and ERV units as specified by client with all associated ductworks and accessories. Volume, cable operated and back draft dampers were installed. Refrigerant and condensate piping provided and installed as well as thermostats and leak detectors. We carried out air-balancing and provided certified report along with shop and as-built drawings.
#66 / 2014
Davidoff of Geneva
1390 Ave of the Americas, New York, NY, United States
The cigar shop required sophisticated HVAC system to keep the required temperature and humidity. Denair HVAC NYC researched the most sophisticated equipment suitable for this delicate project. Based on this we installed AC units, SHN-20 unit, humidifiers, duct heaters and air curtains. Also, new radiators were provided and installed as well exhaust fans, grilles, diffusers and registers. We fabricated ductwork and installed it with all associated accessories. Refrigerant and condensate piping was provided as well as pressure steam lines. All required thermostats, humidistats, leak and smoke detectors were furnished and installed. We performed air balancing and provided certified report.
#64 / 2014
67 Prince St, New York, NY, United States
This project required mechanical package of air conditioning unit, new steam radiators, exhaust fans. We produced and installed ductwork inside and outside and all associated accessories. Volume, fire and motorized dampers were installed. All necessary piping was provided from our end, including refrigerant, condensate and LP steam piping. Required thermostats, leak and smoke detectors were furnished and installed as per client’s specifications. Air balancing was performed and supporting report was provided as well as shop and as-built drawings.
#63 / 2014
245 5th Ave, New York, NY, United States
In this building the works were done in two floors 4th and 17th. Denair HVAC completed the project within the given time and budget. The job involved demolition of existing equipment and installation of AC units, duct heaters, exhaust fans. Inspection of existing radiators was carried out. Based on the inspection, the radiators were relocated. Denair HVAC NYC produced and installed ductwork, branches and accessories. Also, volume, fire, fire/smoke and motorized dampers were installed. All necessary piping was also provided by Denair, such as condensate piping and condenser water S&R piping. Thermostats and leak detectors were provided and installed. By the end of the project, air test and balancing was performed and certified report provided. Client also was provided with all associated shop and as-built drawings.
#62 / 2014
1501 Broadway, Brooklyn, NY, United States
Denair HVAC NYC furnished and installed 500 CFM exhaust fan with associated ductwork, supply and return grilles, diffusers and registers. Furnished and installed volume, cable operated, back draft and fire dampers and performed air balancing providing associated certified report.
#61 / 2014
Crohn’s & Colitis Foundation of America
386 Park Ave S, New York, NY, United States
This wasn’t a big HVAC project, which required installation of new radiators and relocation of the existing. The project was completed in shortest time with customer’s satisfaction.